Figure 46. Distributor, coil, points, condenser, and resistor, removal, adjustment and installation.
spark plug installed in number 1 cylinder.
(7) Stop the engine, disconnect the neon light,
and connect the spark cable to the spark
(3)
Connect a neon timing light between
plug.
number 1 spark plug and cable.
(8) Close the cover and tighten the screw (fig.
(4)
Loosen the distributor mounting screws
and start the engine.
(5)
Hold the timing light directly in front of the
100. Spark Plugs and Cables
flywheel opening in the flywheel housing.
a. Removal.
(6)
Rotate the distributor in either direction
(1) Remove all dirt and foreign matter
until the timing mark alines with the center
hole in the flywheel housing. Tighten the
distributor mouting screws.
Repeat
adjustment as necessary.
AGO 6819A
90
