NOTE
In some cases, the bearing (10) may
remain in the housing and in other
cases may remain on the shaft.
(9) Pull the bearing (10) from the rotor shaft or
press it out of the housing, whichever is required.
(10) Press the seal out of the intermediate
housing. Discard this seal when it has been removed. A
new seal should always be used when reassembling the
(11) Further disassembly of the unit is not
required unless the following tests indicate a defective
component.
1. Screw
23.
Rectifier and lead
45.
O-ring
2. Washer
24.
Rectifier and lead
46.
Nut, hex
3. Sleeve seal
25.
Stud
47.
Regulator
4. key
26.
Nut, hex
48.
Bearing
5. Fan and hub
27.
Insulator, support
49.
O-ring
6. Seal, lip
28.
Screw
50.
Spacer
7. O-ring
29.
Housing, intermediate
51.
Screw
8. Screw
30.
Gasket
52.
Housing, D.E.
9. Housing, anti D.E.
31.
Capacitor and lead
53.
Plug, pipe
10. Bearing
32.
Clamp
54.
Gasket
11. O-ring
33.
Screw
55.
Plate, cover
12. Stator end terminal
34.
Cover
56.
Lockwasher
13. Rotor
35.
Lockwasher
57.
Screw
14. Seal
36.
Screw
58.
Spacer
15. Mount, rectifier
37.
Screw
59.
Washer, guard
16. Mount, rectifier
38.
Pin
60.
Screw
17. Bushing
39.
Holder, brush
61.
Nut, lock
18. Insulator, mount
40.
Washer, guard
62.
Nut, hex
19. Washer, insulator
41.
Screw
63.
Panel, capacitor
20. Washer, guard
42.
Brush
64.
Nut
21. Lockwasher
43.
Connector, socket
64.
Nut
22. Screw
44.
Screw
3-6
