Figure 3-15. Cartridge assembly removal (Model 2385).
(a)
Shaft seal assembly. Install the
d. Reassembly and Installation.
shaft wiper (31, fig. 3-14) in the body (13).
(1) Reassembly.
Grease the shaft seal (32)
and press it into
the body. The spring on the shaft seal must be
NOTE
toward the bearing (8). Place the washer (11) in
Coat all parts with clean OE10 to facilitate
the body against the shaft seal.
reassembly and provide initial lubrication.
(b) Shaft assembly.
Support
the
Use small amounts of petroleum jelly to hold
bearing inner race and press in the shaft (9). In-
the O-rings in place during assembly Soak
the shaft wiper in oil before assembly.
3-32
