TM 5-3810-288-12
Table 3-2. Troubleshooting-Continued
Malfunction
Probable cause
Corrective action
a.
a.
7. Lights fail.
Defective or burned out lamps.
b.
b.
Short in wiring.
c.
Defective switch.
c.
d.
d.
Loose connections.
8. Lights dim.
a. Lens dirty.
a. Clean lens.
b. Faulty ground.
b. Clean ground terminal.
9. Revolving frame will not
a. Swing clutch improperly adjusted
swing.
b. Swing brake engaged.
c. Swing lock engaged.
d. Refer to direct or general support
d. Swing shaft broken.
maintenance.
10. Revolving frame teeters.
Hook rollers improperly adjusted
11. Crane will not lift rated
a. Front or rear drum clutch slips.
capacity.
b. Engine not delivering full power.
b. Refer to direct or general support
maintenance.
c. Some mechanical item binding in
c. Refer to direct or general support
power transmission system
maintenance
a. Pay out cable and respool properly
12. Cables flatten out or wear a. Cable improperly spooled on
excessively.
drum.
b. Sheaves seized on shafts.
b. Loosen sheaves and lubricate per
lubrication chart
c. Cable out of sheave.
c. Place cable in sheave.
d. Cable clamps or sockets incor-
d. Install so the loaded side presents
rectly installed.
a straight line pull through the eye of the
socket.
13. Boom will not raise.
a. Boom hoist clutch slips.
b. Boom hoist mechanical component b. Report to direct or general support
failure.
maintenance.
c. Boom already in highest position.
c. Lower boom.
14. Boom will not lower.
a. Boom supported on safety pawl.
a. Lift boom slightly, disengage pawl
and lower boom.
b. Adjust boom hoist planetary pawls
planetary pawls improperly ad-
justed.
15. Hard lever or pedal
a. Incorrect adjustment.
operation or excessive play
b. Lack of lubrication.
b. Lubricate. See lubrication order.
16. Clamshell operates
a. Rear drum brake dragging
erratically
b. Adjust front and rear drum clutches (para
c. Bucket hinges not lubricated.
c. Lubricate hinges per lubrication order.
3-27