TM 5-3810-288-12
Figure 3-32. Carburetor, removal and replacement.
(a) Refer to figure 3-99 and remove radiator
(g) Remove one nut and three washers from the
shutters and sheet metal as required.
mounting studs on each side.
(b) Remove upper connection hoses and hose
(h) Remove radiator braces.
One brace is on
clamps (fig. 3-47).
each side of the engine.
(c) Remove all fan guard
capscrews
and
(i) Lift radiator until mounting studs clear the
lockwashers and remove fan guard.
mounting brackets. Then remove the radiator through the
rear of the cab where rain shutters and sheet metal have
(d) Remove lower connection hoses and hose
been removed.
c. Thermostat, Housing, Gasket, and Lines.
clamps.
(e) Remove drain line hose clamps.
Service.
(1)
Keep the thermostat
housing and lines tightened so that they do not leak.
(f) Support the radiator so it can not fall and
Wipe
attach a suitable lifting device.
3-39
