TM 5-3810-288-12
STEP 1.
STOP ENGINE. DISCONNECT FUEL LINES.
STEP 2.
REMOVE BOLTS AND LOCKWASHERS. REMOVE-FUEL PUMP WITH
SEDIMENT BOWL AND GASKET FROM ENGINE.
STEP 3.
POSITION FUEL PUMP ON ENGINE WITH GASKET BETWEEN PUMP AND ENGINE.
INSTALL BOLTS AND LOCKWASHERS. RECONNECT FUEL LINES.
STEP 4.
TO SERVICE SEDIMENT BOWL, LOOSEN KNURLED NUT AT THE BOTTOM OF
BOWL, SWING BAIL ASIDE, AND REMOVE BOWL.
STEP 5.
WIPE OUT SEDIMENT BOWL WI TH CLEAN CLOTH. INSTALL NEW GASKET ABOVE
BOWL, POSITION BOWL IN HOUSING, SWING BAlL UNDER BOWL AND TIGHTEN
KNURLED NUT.
ME 3810-288-12/3-35
Figure 3-35. Fuel pump and fuel sediment bowl, removal and replacement.
Warning: Always disconnect battery cables be-
alternator-water pump belts.
fore working on electrical components
.
repair or replacement, belts, mount- ing bracket, and
b. Alternator.
wiring must be inspected for slippage, fraying, broken
wiring, grounds, or other faults. After these items have
been checked and found in order, an electrical check
alternator belt tension. Note that the alternator belts also
may be made, as follows:
drive the water pump, and that water pump belt tension
is being ad- justed at the same time.
3-42
