TM 5-3810-288-12
(b) Spread the bands and remove the
air cleaner.
(2) Replacement. Refer to figure 7-9 and
replace the air cleaner as follows:
(a) Spread the bands and install the air
cleaner in the bands as shown.
(b) Install the screws and nuts in the
bands. Slide the hose over the air intake pipe
and tighten the hose clamps.
h. Engine Speed Governor.
adjust the engine speed governor.
move the engine speed governor as follows:
(a) Remove the cotter pin and pin to
dis-connect the governor linkage from the
governor. Disconnect the oil lines.
(b) Remove the capscrew and washer
from the governor spring bracket. Remove the
nuts and governor mounting damp. Remove the
governor.
replace the governor as follows:
(a) Position the governor on the engine,
install the governor mounting damp on the top
mounting stud, and install the nuts on the
mounting studs.
(b) Attach the governor spring bracket
to the engine with the capscrew and washer.
Connect the governor linkage to the governor
with the pin and secure the pin with the cotter
Figure 7-15. Carburetor, adjustment, removal and
pin.
replacement. (Sheet 2 of 2)
(c) Connect the oil lines as shown.
Check the adjustment of the governor as
carburetor as shown and secure it to the carburetor with
described above.
the pin and cotter pin. Connect the fuel line.
i. Engine Starting Aid Pump and Lines.
(c) Install the accelerator linkage on the
and remove and replace the engine starting aid
carburetor and tighten the screw in the end of the
pump.
Note that the bottom of pump (7)
accelerator linkage. Position the throttle cable as shown
unscrews from the top portion of the pump.
and install the clamp, screw and nut. Slide the hose over
the carburetor air intake and tighten the hose damp.
Adjust the carburetor as described above.
lines or fittings.
j. Accelerator and Throttle.
g. Air Cleaner.
(1) Replacement. Refer to figure 7-18 and
(1) Removal. Refer to figure 7-9 and remove
remove and replace the accelerator and throttle
the air cleaner as follows:
control.
(a) Loosen the hose clamps and slide the hose
any damaged portion of the accelerator or
off the air intake pipe. Remove the screws and nuts on
throttle control.
the bands.
7-18
