TM 5-3810-288-12
1.
Lever, main transmission control
8.
Rod, transfer case control, rear
2.
Lever, transfer case control
9.
Lever, front axle drive
3.
Lever, front axle control
10.
Rod, front axle control, rear
4.
Bracket, control lever
11.
Idler, shifter rod
5.
Lever
12.
Pin, yoke
6.
Rod, transfer case control
13.
Rod, front axle control, rear
7.
Lever, idler
14.
Rod, main transmission control
Figure 7-57. Gear shift control, repair and replacement
and remove the end. Withdraw the flexible core from
.7-59.
Data Plates
within the sheath. Install a new flexible core in the
The data plates are mounted on the machine with
sheath from the gage end, and attach the ends of the
screws, lockwashers, and nuts. The lockwashers and
flexible drive with the knurled nuts.
nuts are placed behind the mounting panel.
c. Drive cable installation. Install the new drive
7-60. Fire Extinguisher
cable in the same damps as the old cable, and attach
Replace fire extinguishers which have been used, the
the ends of the cable with the knurled nuts.
seals of which have been broken, or which have lost
7-62. Boom Rest
weight of pound or more, with a like serviceable item.
a. Removal. Refer to figure 7-62 and remove the
7-61. Speedometer and Tachometer Drive
boom rest.
a. General. Customarily, only the flexible core of
b. Replacement. Replace the boom rest on
the speedometer or tachometer drive is re-placed and a
the machine as shown in figure 7-62.
method of replacing it is described below. In the event
7-63. Tool Box
that the entire cable must be replaced, a method of
a. Removal. Refer to figure 7-63 and remove the
replacing it is also described.
b. Flexible core replacement. Loosen the
tool box.
b. Replacement. Replace the tool box as shown in
knurled nuts at each end of the flexible drive cable
7-64
