TM 5-3810-288-12
(2) Refer to figure 7-56 and adjust the clutch
7-53. Propeller Shafts
pedal free travel.
a. General. The locations of the four propeller
shafts used on this machine are shown in figure 7-58.
(3) Depress the clutch several times and re-
The propeller shafts which connect the driving axles to
check the clearance specified in step (1) above.
the transfer case are identical with the exception of their
length.
(4) Hold the clutch pedal down while the sleeve
locknut is turned up to the release lever spider and
b. Main Transmission Propeller Shaft Replace-
securely tightened.
ment. Refer to figure 7-58 and remove the cap-screw,
lockwashers, and nuts which connect the flanges at each
Note. Always disengage the clutch while the
end of the propeller shaft, and remove the propeller
sleeve locknut is being locked or unlocked hut have the
shaft. Install the propeller shaft as shown in figure 7-58.
clutch engaged while turning the threaded sleeve to
obtain the proper distance which must he checked and
c. Driving Axle Propeller Shaft Replacement.
maintained as wears occurs.
Refer to figure 7-58 and bend the lock straps away from
the capscrews. Remove the capscrews, lock straps, and
Note. The sleeve locknut (spanner nut) must be
turned up against the release lever spider and securely
the propeller shaft. In-stall the propeller shaft as shown
locked. This can be accomplished by the use of a punch
in figure 7-58.
and hammer or spanner wrench.
7-54. Differential Service
Check the oil level in the front and rear differentials. The
oil should be just up to the level plug opening. Add oil of
the type listed in the lubrication order as required to bring
the level to the oil level plug opening.
7-55. Outriggers
a. Replacement. Refer to figure 7-59 and re-move
and replace the outriggers.
b. Repair. Refer to figure 7-60 and remove any
rust or corrosion from the outrigger beams and boxes,
and paint in accordance with TM 9-213. Replace any
damaged or bound outrigger beam roller or jack screws,
and damaged outrigger box pins, eye pins or capscrews.
Report any broken or cracked welds to the proper
authority.
7-56. Seat
a.. Removal. Refer to figure 7-61 and remove the
capscrews, lockwashers, and nuts, and remove the seat.
b. Installation. Refer to figure 7-61 and install the
seat as shown.
7-57. Cab
Refer to figure 7-26 and remove and replace any
damaged cab sheet metal.
7-58. Fender
Refer to figure 7-26 and remove or install the fenders.
Figure 7-56. Clutch control, adjustment
7-52. Gear Shift Controls
Refer to figure 7-57 and repair or replace components of
the gear shift control as required
7-63
