Storage
DEROIT DIESEL
Remove the covers from the turbocharger air inlet and
Remove the inspection hole cover and inspect the
turbine outlet connections. Refer to the lubricating
clutch release lever and link pins and the bearing ends
procedure outlined in Preparation for Starting Engine
of the clutch release shaft. Apply engine oil sparingly, if
First Time.
necessary, to these areas.
18. After all of the preparations have been completed,
16. HYDROSTARTER
start the engine. The small amount of rust preventive
a. Open the relief valve on the side of the hand
compound which remains in the fuel system will cause a
pump and release the pressure in the system.
smoky exhaust for a few minutes.
b. Refer to the filling and purging procedures
outlined in Hydraulic Starting System. Then,
NOTE: Before subjecting the engine
drain, refill and purge the Hydrostarter system.
to a load or high speed, it is
17. TURBOCHARGER
advisable to check the engine tune-
up.
Page 120
