STEP 1.
LOOSEN LOCKNUTS (4) WHICH SECURE ADJUSTING BOLTS (4).
STEP 2.
TURN ADJUSTING BOLTS OUT OF CONTACT WITH CLUTCH BANDS. CLUTCH BANDS MUST BE
CENTERED IN CLUTCH DRUM. USE ADJUSTING BOLTS (4) TO CENTER CLUTCH BANDS. TIGHTEN
LOCKNUTS.
STEP 3.
LOOSEN LOCKNUT ON CYLINDER ROD.
STEP 4.
TURN CYLINDER ROD OUT UNTIL A PULL OF 15 TO 20 POUNDS ON A SPRING SCALE IS NEEDED TO
ENGAGE THE CLUTCH. TIGHTEN LOCKNUT.
NOTE: ONLY STEPS 3 AND 4 ABOVE ARE NECESSARY TO ADJUST FOR LINING WEAR.
USE COMPLETE
PROCEDURE ONLY WHEN CLUTCH HAS BEEN REMOVED AND REPLACED.
ME 3810-288-12/3-9
Figure 3-19. Adjusting front and rear drum clutch.
3-22
