STEP 1. LOOSEN LOCKNUTS ON ADJUSTING SCREWS.
STEP 2. REFER TO FIGURE 2-32 AND ENGAGE THE SWING CLUTCH LEVER.
STEP 3. BACK OFF ON ALL ADJUSTING SCREWS UNTIL THERE IS A 0.020 INCH GAP BETWEEN HEADS OF
ADJUSTING SCREWS AND CLUTCH SHOES.- TIGHTEN LOCKNUTS AND RECHECK GAP.
NOTE:
MAKE ABOVE ADJUSTMENT FOR FIRST ONE CLUTCH SHOE AND THEN THE OTHER.
BE SURE
CLUTCH SHOES DO NOT DRAG.
ME 3810-294-10/3-21
Figure 3-21. Adjusting reversing shaft clutch or horizontal swing shaft clutch.
b. Adjust. The adjustment of both of these
3-36. Front and Rear Drum Brake Service and
brakes is identical and is done with hydraulic pressure
Adjustment
off. No pressure should be placed on the operating foot
a. Service. Keep the mechanical components of
pedal. Refer to figure 3-22 and adjust the front or rear
the rear drum brake clean and dry. Do not allow
drum brake.
hydraulic fluid to come into contact with brake linings.
3-26
