TM 5-3810-294-34
(4) Remove retaining rings (14), felt washers
(1) Install new bushing (30, fig. 18-2) if
(15), and retainers (16), from anchor pins (17)
required.
(5) Cut lock wire (31) and remove lock screws
(2) If any washers were removed from cam
(32).
and spider during disassembly, install same
(6) Remove anchor pins (17), sleeve (18), and
washers as shown.
brake shoe assembly (20).
(3) Install cam (26) with assembled washers
(7) Remove shoe rollers (23) and pins (25)
through spider (33) and bracket (37).
(8) Disconnect slack adjuster body (11) from
(4) Install slack adjuster (1-1 1) to cam, then
brake chamber (40).
install retainer (46).
(9) Remove retainer (46), then remove slack
(5) Connect slack adjuster to brake chamber
adjuster (1 thru 11). Remove cam (26).
(40).
(10) Remove bushing (30) from spider (33)
(6) Install rollers (23) and roller pins (25).
only if replacement is necessary.
(7) Install bushings (18) and anchor pins (17)
(11) If other brake components must be
to brake spider(33). Secure anchor pins with screws
replaced remove, disassemble, reassemble, and
(32), then insert lock wire through heads of screws.
install parts as shown in figure 18-2.
(8) Position brake shoes (20) over anchor pins
b. Cleaning, Inspection and Repair.
(17), and install retainers (16), felt washers (151,
and retaining rings (14).
( 1 ) Clean all parts except brake linings with an
(9) Install brake shoe return spring (19).
approved cleaning solvent and dry thoroughly.
(10) Install hub and drum assembly (refer to
(2) Inspect brake linings for excessive wear
para 17-5).
Lining worn to within 1 / 16 inch of rivet heads
(11) Install rear wheels (refer to TM 5-3810-
should be replaced.
294-20).
(3) Inspect all parts for excessive wear or other
(12) Adjust rear brakes (refer to TM 5-3810-
damage, and replace defective parts.
c. Reassembly and Installation.
294-20).
18-5
