TM 5-3810-295-34
blower drive gear support and tighten the clamp to hold the seal in place.
g. Check backlash between the bower drive gear and the camshaft gear Backlash should be 0.003 to
0.007 inch.
h. Refer to TM 5-3810-295-12 and install air inlet housing and air filter.
Section VIII. REPAIR OF FUEL TANK
3-43. Description
The fuel tank is located in the crane engine compartment, and provides the function of fuel storage and supply for the
crane engine.
3-44. Removal
a
Refer to figure 3-9 and open drain cock (12).
Drain fuel into a suitable container.
b. Remove hose clamps (1), hose (2), and plate (3).
Remove screws (4) and electrical lead (5).
c
Remove nuts (6) and washers (7), and lift the tank assembly from the engine compartment.
3-18