TM 5-3810-295-34
CHAPTER 9
REPAIR OF CAB AND WIRING HARNESS
Section I. REPAIR OF WIRING HARNESS AND BATTERY CABLES
c. Inspect battery cables and terminal for
9-1. Cleaning and Inspection
excessive corrosion, breaks or other damage. Inspect
battery acid for proper level. Inspect wiring for breaks,
WARNING
damage or loose connections.
Disconnect battery before working on electrical system
9-2.
Repair
and/or components.
Splice minor breaks in wiring, and wrap with electrical
tape. Replace excessively damaged wires and
a. Refer to the wiring diagram in TM 5-3810-295-12
terminals.
for identification if necessary.
b. Clean battery terminals and cable lugs. Clean any
other wire or terminal that is corroded and in a troublesome
circuit.
Section II. REPAIR OF CAB
c. Straighten and repaint minor dents or scratches
9-3.
Removal and Disassembly
in sheet metal. Replace broken glass and damaged
Refer to figure 2-1 and disassemble cab components and
weather stripping. Replace all other excessively
sheet metal as required.
damaged parts.
9-4.
Cleaning, Inspection and Repair
a. Clean excessively dirty cab components with warm
soapy water and dry thoroughly.
9-5.
Reassembly and Installation
b. Inspect threaded parts for excessive wear or
Refer to figure 2-1 and reassemble cab parts as re-
damage. Inspect sheet metal for breaks, cracks or other
quired.
damage. Inspect weather stripping for breaks or excessive
stiffness.
9-1/(9-2 blank)
