TM 5-3810-295-34
CHAPTER 12
DIRECT SUPPORT AND GENERAL SUPPORT
MAINTENANCE INSTRUCTIONS
Section I.
REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
12-1. Special Tools and Equipment
12-2. Maintenance Repair Parts
There are no special tools or equipment needed to
Repair parts for the M320RT truck crane carrier are
perform direct o general support maintenance on the
listed and illustrated in the repair parts list, TM 5-3810-
M320RT truck crane carrier.
29534P.
Section II.
TROUBLESHOOTING
c. Table 2-1 lists the common malfunctions that you
12-3. Scope
may find during the operation or maintenance of the
a. This section contains troubleshooting or malfunc
M320RT crane or its components. You should perform
tion information and tests for locating and correcting
the test inspections and corrective actions in the order
most of the troubles which may develop in the M320RT
listed.
crane. Each malfunction or trouble symptom for an
12-4. Troubleshooting
individual component, unit, or system is followed by a list
of tests or inspections necessary for you to determine
Refer to table 2-1 and troubleshoot the M320RT as
probable causes and suggested corrective actions for
required.
you to remedy the malfunction.
NOTE
b. This manual cannot list all possible malfunctions
Before you use this table, be sure you
that may occur or all tests or inspections, and corrective
have performed all normal operational
actions. If a malfunction is not listed (except when
checks. If you have a malfunction which
malfunction and cause are obvious), or is not corrected
is not listed in this table, notify the next
by listed corrective actions, you should notify higher level
higher level of maintenance
maintenance.
Section III. GENERAL MAINTENANCE
procedure, the above paragraphs should be read and
12-5. General
adhered to.
General maintenance is discussed in chapter 2 (para 2-5
through 2-9). Prior to attempting any disassembly
Section IV. REMOVAL AND INSTALLATION OF CARRIER MAJOR COMPONENTS
NOTE
12-6. Engine and Torque Converter
a. General.
The engine and torque converter
When disconnecting leads and wires,
they must be identified for proper
assembly should be removed from the carrier as a single
reconnection.
unit.
(4) Drain and disconnect fuel lines at the fuel
b. Removal
pump. Cap all disconnected fuel lines immediately (TM
(1) Refer to TM 5-3810-295-12 and remove all
5-3810-295-12)
deck plates over the engine assembly.
(5) Disconnect and tag all hydraulic lines.
(2) Refer to TM 5-3810-295-12 and drain the
cooling system. Remove all radiator hoses, air cleaner,
(6) Refer to paragraph 15-8b and disconnect the
universal joint from torque converter to transmission.
(3) Refer to TM 5-3810-295-12 and disconnect
(7) Refer to figure 12-1, and attach a suitable lifting
battery cables, throttle linkage, air compressor lines, and
device to the engine. Remove engine mounting bolts
engine wiring.
and lift the engine and torque converter assembly from
the carrier.
Change 1 12-1
