TM 5-3810-295-34
cylinder head. Cylinder liner walls shall be clean and
Washers and headbolts shall be coated with clean
well lubricated with clean engine oil.
engine oil. Snug tighten headbolt of each head in se-
quence of figure 14-7.
NOTE
e. Install tube connector (8, fig. 14-18), and tube
Install tappets as instructed in paragraph
nut (7). Install new packing (6) and dowels (5).
14-15.
f. Place intake and exhaust crossheads (1) and (2)
b. Install head gasket (13) over ring dowels so
over crosshead guides. Hold crosshead firmly down on
word "'TOP" on gasket is visible. All bolt holes in the
mating valve stem. Run crosshead adjusting screw (4)
gasket must be aligned with holes in the block.
down until it just touches valve stem. Snug tighten
c. Lift cylinder head (12) with suitable hoist and
locknuts (3).
lower into place over ring dowels.
d. Install washers (11), and headbolts (9) and (10).
Section VI. FLYWHEEL, FLYWHEEL HOUSING, GEAR HOUSING AND OIL PAN
(6).
14-22. Removal and Disassembly
(2) Remove screws (7, 8, 9 and 10), washers
a. Refer to figure 14-19. Remove and disassemble
(11) and 13) lock washers (12 and 14), pan (15), and
the oil pan as follows:
gasket (16).
(1) Remove by-pass tube (1), section tube (2),
gasket (3), drain back tube (4), elbow (5) and adapter
14-19
