TM 5-3810-295-34
TA033376
Figure 15-11. Torque converter assembly-exploded view (sheet 2 of 2).
(2) Remove screws (5). Install two bolts in
(7) Remove retaining ring (19), backing plate (20),
threaded holes of bearing cap (6). Turn the bolts evenly
inner disc (21), outer disc (22), inner disc (23), and
and remove bearing cap (6) preformed packing (7), and
lockup piston (24).
retaining ring (8).
(8) Remove piston ring (25), plastic seal (26),
(3) Remove screws (9) and lock washers (10).
piston ring (27), and preformed packing (28) from im-
Using a suitable puller remove bearing retainer (11),
peller cover (29).
bearing (12), piston ring (13) from turbine shaft (72).
(9) Remove nut (30) and lock washer (31) and lift
(4) Remove bolts (14) and lock plate (15) from tur-
bearing cap (32) off cover (47). Remove preformed
bine (109).
packing (33), lube tube (34), shim (35) and preformed
packing (36).
CAUTION
(10) Remove piston ring (37) from adapter (39).
Secure impeller cover (29) with a chain to pre-
Remove cap screw (38) and install two bolts in
vent assembly from dropping.
threaded holes of adapter (39). Turn bolts evenly to
(5) Block impeller cover (29) on the outer diameter
remove adapter (39) from cover (47).
and drive turbine hub and cover assembly from shaft
(11) Using a soft bar, lock output gears (65) and
(72).
remove cotter pin (40) and nut (41). Remove washer
(6) Straighten tangs on lock plates (17) and
remove screws (16), lock plates (17) and plates (18)
from cover.
15-20
