TM 5-3810-295-34
d. Insert a metal bar through the differential. Raise
i. Remove pinion (44), bearing (45), and oil tube (46),
the end of the bar and remove adjusting nuts (7) and
Remove bearing cone (47), and press bearing cup (48)
bearing cups (8). Hoist differential from the carrier as-
from carrier. Remove oil retainer (49), thrust nut (50),
and thrust screw (51). Remove locating dowel (52).
sembly.
Press bearing cup (53) from carrier housing.
e. Remove lock wire (9), nut (10), washer (11), and
j. Remove bearing (54) from ends of the differential
pull drive flange (12) and dust shield (13) from the in-
case. Match mark the case halves to assure correct
put shaft. Remove screws (14) and washers (15). Using
reassembly.
puller screws (16), remove retainer (17). Drive oil seal
k. Remove nuts (55) and bolts (56). If necessary, use
(18) from retainer (17). Remove shims (19).
a soft mallet to break the seal between case halves (57)
f. Remove bolts (20), screws (21), lock washers (22),
and (58). Lift plain case half (57) from the assembly.
and nuts (23). Remove drop gear cover (24) and gasket
l. Remove thrust washer (59) and differential gear
(25). Press bearing cup (26) from drop gear cover.
(60). If necessary, remove thrust washers (61) and
Remove input shaft as an assembly and remove bear-
pinions (62), and remove spacers (63), needle rollers
ing cone (27), drop gear (28), and bearing cone (29)
(64) and spacers (65) from spider (66).
from input shaft (30).
m. For rear axle differential refer to figure 16-4.
g. Remove cotter pin (31), shaft nut (32) and washer
Note that the two units are identical except that the
(33). Using a suitable puller, remove pinion drive gear
rear axle has a "no spin" differential unit. To dis-
(34). Remove bearing cone (35).
assemble the no spin unit, remove side gear (59), side
h. Break lock wire (36) and remove screws (37) and
gear springs (60), and spring and clutch (61). Remove
(38). Remove bearing cage (39), oil retainer (40), shim
cam and clutch (62), holdout ring (63), and snap ring
(41), and bearing spacer (42). Press bearing cup (43)
(64) from spider (65). Remove center cam (66).
from cage (39).
16-8
