TM 5-3810-295-34
1 Bolt
13 Washer
25 Screw
2 Washer
14 Needle bearing
26 Clamp
3 Nut
15 Cap screw
27 Guide
4 Lock washer
16 Lock washer
28 Ball
5 Cover
17 Cover
29 Ball nut
6 Gasket
18 Shim
30 Housing
7 Seal
19 Seal
31 Pipe plug
8 Needle bearing
20 Cup
32 Nut
9 Lock nut
21 Worm shaft
33 Adjuster
10 Pitman shaft
22 Bearing
34 Expansion plug
11 Retainer
23 Bearing
35 Cup
12 Adjuster
24 Ball nut stop
Figure 17-7. Steering gear box-exploded view.
(5) Remove needle bearing (8) from housing
(7) Using a suitable puller, remove needle
(30) using a suitable puller.
bearing (14) from side cover (5).
(6) Remove lock nut (9) from adjuster screw
(8) Remove cap screws (15) and lock washers
(12). Remove pitman shaft (10) from side cover (5) by
(16) and remove cover (17) from housing (30). Remove
turning adjusting screw (12) clockwise.
shims (18) and record the number removed.
(9) Remove the worm shaft (21) and nut ball (29)
NOTE
assembly from housing (30).
Retainer (11) adjuster screw (12) and
(10) Pry seal (19) out of cover (17) with a
washer (13) should not be removed from
screwdriver and discard. Care must be taken not to
pitman shaft (10).
Retainer (11) is
damage seal bore in cover.
tacked into pitman shaft and complete
(11) Using a suitable puller, remove bearing cup
assembly should be replaced if
necessary.
17-10
