TM 5-3810-295-34
(20) from cover (17).
end housing (7).
(12) Slide bearing (22) off worm shaft (21) and
(6) Remove ball stud seats (9), washer (10), and
lift bearing (23) from inside gear housing (30).
spacer (11) from cap of spool bolt (13) in sleeve (15).
(13) Remove ball nut stop (24) from worm shaft
(7) Remove valve spool assembly from valve
(21).
body (34) and remove nut (12), bolt (13) and washer
(14) Remove screws (25) and retaining clamp
(11).
(26) from ball nut (29). Remove guides (27) from ball nut
NOTE
(29).
Sleeve (15) must be held against spools (22) to keep
(15) Remove balls (28) by turning ball nut (29)
spring (17) from releasing.
upside down and rotating the worm shaft (21) back and
(8) Slowly release sleeve (15), removing spring
forth until all balls have dropped out of the nut.
washer (16), centering spring (17), spacer (18), spring
(16) Unscrew ball nut (29) off end of worm shaft
washer (19), retainer (20) and performed packing (21)
(21).
from valve spool (22).
(17) Remove pipe plug (31) from housing (30).
(9) Remove nut (23), washer (24) and bolt (25).
Remove lock nut (32) and back-off adjuster (33) from
Remove end cap (26) from valve body (34).
housing (30).
(10) Remove preformed packing (27), check ball
(18) Place gear housing (30) in an arbor press
plug (28) and ball (29) from valve body (34).
and using a suitable size socket, press expansion plug
(11) Remove spacer (30), retainer (31) and
(34) and bearing cup (35) out of housing (30).
preformed packing (32) from valve body (34).
c. Refer to figure 17-8 and disassemble the
(12) Remove preformed packing (33) from valve
power steering control valve as follows:
body (34).
(1) Remove nut (1) from ball stud (5).
(13) Remove plugs (35) and (36) from valve
(2) Remove dust cover (2) from end housing (7).
body (34).
(3) Remove lock wire (3) and adjusting plug (4)
(14) Remove plug (37) and preformed packing
(4) Lift ball stud (5) out of end housing (7).
(38) from valve body (34).
(5) Remove bolts (6) and separate end housing
from valve body (34). Remove grease fitting (8)from
17-11
