TM 5-3810-295-34
(4) Remove clips (6) and lift cushion (7) from seat
19-6. Removal and Disassembly
assembly (5). Remove bumpers (8).
(5) Remove cap screws (9) and lock washb(rs (10).
a. Refer to TM 5-3810-295-12 and remove
Lift back cushion assembly off. Remove clips (12) and
carrier operator's seat.
remove cushion (13) from assembly (11).
b. Refer to figure 19-2 and disassemble
(6) Remove snap rings (14) and top hinge shaft (15)
operator's seat as follows:
through lever assembly (20).
(1) Place wooden shim between base (68)
(7) Remove snap rings (16), washers (17) and (18)
and seat cushion assembly (5) at front of seat.
and hinge shaft (19) from lever assembly (20).
Shim should be approximately 3 inches high to
(8) Remove lever assembly (20) from base (68) and
allow upper seat assembly to drop 1 inch.
remove rollers (21).
(2) Remove pin (1) and rotate adjuster (27)
(9) With a small drift remove roll pin (22) and
counterclockwise to remove preload on torsion bars
taphinge shaft (23) out.
(39).
(10) Lift shock absorber (24) from center lever
NOTE
assembly (46) and remove bearings (25) and (26).
(11) Remove adjuster (27), bearing (28) and
Do not disengage adjuster assembly from
washers (29) from side panel (30).
seat at this time.
(12) Tap side panel off center lever assembly (46)
and remove adjusting pin (31), adjuster yoke (.32) and
(3) Remove nuts (2), lock washers (3) and
bearing housing (33). Remove lube fitting (31) from panel
washers
(30).
(4). Slide seat cushion assembly (5) forward
and lift from assembly.
NOTE
Wire side panel assemblies (30) and (35)
together across the front to retain their
position before removing seat assembly.
19-2
