TM 5-3810-295-34
clips (6).
lock washers (10) and cap screws (9).
(21) Assemble seat cushion assembly (5) to
(23) Preload torsion bars (39) by turning adjusting lever
center lever assembly (46) by moving seat from the
(27) clockwise. Install pin (1) in screw of adjusting lever
front of seat toward the rear being sure to engage
assembly (27).
rollers (24) properly in housing under cushion.
b. Refer to TM 5-3810-295-12 and install carrier
Secure with washers (4), lock washers (3) and nuts
operator's seat assembly.
(2).
c. Refer to TM 5-3810-295-12 and install carrier
(22) Assemble back cushion (13) to back
operator's seat belt assembly.
cushion assembly (11) with clips (12). Install back
cushion assembly (11) to side panels (30) and (35),
secure with
Section III. REPAIR OF CARRIER CAB HEATER ASSEMBLY
(2) Remove screws (5), and lock washers (6). Lift
19-9. Description
housing flange (7) and jacket retainer (8) from housing
The carrier cab heater is a liquid coolant type heater
(16). Separate housing flange (7) and jacket retainer (8).
with a capacity of 20, 000 BTU/HR. The blower
(3) Remove screws (9), lock washers (10) and (13),
motor is a 24 VDC motor controlled by a switch in
and nuts (12). Remove motor and impeller assembly from
the carrier cab.
housing (16).
19-10. Removal and Disassembly
(4) Pull impeller assembly (11) from shaft of motor
a. Refer to TM 5-3810-295-12 and remove the
(14).
carrier cab heater.
(5) Separate motor (14) and flange (15).
b. Refer to figure 19-3 and disassemble the
(6) Remove rivets (17) and data plate (18) from
carrier cab heater as follows:
housing (16).
(1) Remove cap screws (1) and lock washers
(2). Remove heater jacket (3) and core (4).
19-5
