TM 5-3810-300-24&P-3
Crankshaft Front Cover 1.3.5
5. Tighten the cover attaching bolts by following the
6. Apply a light coating of engine oil to the vibration
tightening sequence indicated in Fig. 3. Follow
damper inner cone or the oil seal spacer and
this sequence as the bolts are drawn up and
slide it into place on the crankshaft.
then tightened to their proper torque to effect a
good seal between the mating parts. Tighten the
7. Install the oil pan, using a new gasket.
3/8"-24 bolts to 25-30 lb-ft (34-41 Nm) and the
8. Refer to Lubricating Oil Specifications in Section
1/2"-13 bolts to 80-90 lb-ft (108-122 Nm) torque.
13.3 and refill the crankcase with oil to the
proper level on the dipstick.
PAGE 78
