TM 5-3810-302-10
Disconnect and stow the rear steer cylinder (under right rear fender,
5.
between the wheel the frame) as follows (figure 5-2):
- Remove 1/4-inch bolt and nut which locks the pitman arm ball.
- Using a large screwdriver, back out the socket plug until the steer
cylinder can be raised off the ball on the pitman arm.
- Screw the socket plug back in and replace the 1/4 inch bolt to lock it in
place.
- Stow the cylinder on the pin provided. See figure 5-2.
- Secure the cylinder with the lock pin provided.
- Secure the cylinder with the lock pin provided.
NOTE
With the steer cylinder disconnected and
stowed, the rear wheels are free to follow
the towing vehicle.
CAUTION
DO NOT ACTUATE THE REAR STEER LE-
VER WITH THE CYLINDER DISCONNECT-
ED AND THE ENGINE RUNNING. THIS
WILL DAMAGE THE REAR STEER CYL-
INDER ROD.
Install the rigid Iink (stowed in the left side tool compartment), between
6.
the front wheel pitman arm on the right side, and the clevis provided on the
outrigger box.
- Turn the front wheels until the link can be installed.
- Adjust the link as required to lock the front wheels straight ahead.
Reduce tire pressure to 65 psi.
7.
5-3
