TM 5-3810-302-10
Tow the SCAMP from the rear using a towbar that conforms to
8.
MS5000048, medium duty capacity.
- Fit clevises on towbar to tow/tie-down lugs on the face of the rear
outrigger box. See figure 5-1. Use the lower, 1 -inch diameter holes in
the lugs to attach the towbar.
Perform the following after reaching the destination and before any craning
operation:
1.
Engage rear steer cylinder (figure 5-2) as follows:
- Remove lock pin.
- Remove 1/4-inch bolt.
- Engage socket plug to pitman arm ball.
- Install 1/4-inch bolt and nut.
- Install lock pin to stowage pin on frame.
Remove and stow the rigid link installed on the right-front wheel
2.
pitman arm.
Position the Tow-Drive Lever (18, figure 4-1 ) to DRIVE.
3.
Increase tire pressure to 75 psi.
4.
Remove the turntable lock pin.
5.
Remove hook block at front pintle hook.
6.
AIR TRANSPORT.
TRANSPORT BY CARGO AIRCRAFT.
NOTE
The SCAMP's overall height allows the
crane to be transported without disassembly
by C-130, C-141, and C-5A aircraft.
