TM 5-3810-306-10c.Connect female end of hand pump pressurehose to male fitting located on inside surface ofleft hand carrier side rail.d.Close shut-off valve located near connectionmade in step c. This valve must be closed tomanually retract outriggers.e.Locate front outrigger valve stack (back side offront outrigger box). Locate rear outrigger valvestack (inside surface of left hand carrier side railjust forward of rear outrigger box).f.Locate four (4) quick couplers (four on eachoutrigger valve stack). The two inside couplersretract jack cylinders. The two outside couplersretract extension cylinders (beams).g.Connect 38-foot long hose (with couplers oneach end) to quick coupling on back of hydraulicreservoir. This is the hydraulic return line.h.Select first jack cylinder to be retracted.i.Connect free end of hydraulic return line toappropriate quick coupler on front (or rear)outrigger valve stack. Jack cylinders areretracted using the two inside quick couplers oneach valve stack.j.Pump hand pump until jack cylinder iscompletely retracted.k.Repeat steps i and j for each of the other threeoutrigger jack cylinders.l.Select first extension cylinder (beam) to beretracted.m. Connect free end of hydraulic return line toappropriate quick coupler on front (or rear)outrigger valve stack. Extension cylinders areretracted using the two outside quick couplers oneach valve stack.n.Pump hand pump until extension cylinder(beam) is completely retracted.o.Repeat steps m and n for each of the other threeoutrigger extension cylinders.p.Disconnect all hoses and reinstall dust capswhere provided.q.Open shut-off valve that was closed in step d.7.Stow equipment.a.Disconnect hand pump pressure line. Cap allquick disconnect couplings.b.Coil three (3) hoses and stow them in tool box.c.Remove pump handle and stow it in tool box.8.When towing crane, refer to shipping plate posted oncrane and use towing lugs provided.2-57
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
