TM 5-3810-307-10
b.
Only one person should be strapped in each seat belt.
c.
To lengthen the belt, tip the buckle end downward, as shown, and pull the
buckle until the belt ends can be joined. Insert the belt into the open end of
the buckle until a snap is heard and check for latch engagement. This belt
can be shortened, after connection, by pulling on the loose end until the belt
is snug. Press the buckle release to remove the belt.
Figure 5-6. Seat Belt Adjustment
5-6.11
Traveling - Forward.
CAUTION
Engage the SWING LOCK Pin Control Lever (49,
CAUTION
Use four wheel drive only when required for more
traction.
a.
Position the DRIVE AXLE Selector Switch (37) to either high speed (2WD)
or low speed (4WD).
b.
After the engine has warmed up, shift Transmission Shift Lever (48) from N
(neutral) to the forward (F) gear desired. The carrier backup/ superstructure
driving lights will come on and the backup alarm mounted on the rear of the
carrier will sound when driving the crane forward from the superstructure
cab.
c.
Release the PARK BRAKE Control (57) and depress the Foot Throttle Pedal
(5).
5-75
