TM5-3810-307-10
n.
Attach a nylon lifting sling to the lead head adapter and using the pile line (aux.
hoist), hoist and remove the lead head adapter.
o.
Attach two lifting slings with 3/4-inch shackles to the pile gate and using the pile
line (aux. hoist), hoist and remove the pile gate.
p.
Remove the pile gate stop and the lead transportation chain from the square
(concrete) pile adapter.
q.
Attach the nylon lifting sling to the foot roller assembly and using the pile line (aux.
hoist), hoist and remove the foot roller assembly.
r.
Attach two lifting slings with 3/4-inch shackles to the sheet pile adapter and using
the pile line (aux. hoist), hoist and remove the sheet pile adapter.
s.
Attach two lifting slings with 3/4-inch shackles to the square (concrete) pile adapter
and using the pile line (aux. hoist), hoist and remove the square (concrete) pile
adapter.
t.
If not already attached, attach the 89-inch lifting sling with a 7/8-inch shackle to the
upper cylinder lifting lug on the impact hammer (center of upper cylinder) and
attach the 96-inch lifting sling with a 7/8-inch shackle to the lower cylinder lifting lug
(at top of direct drive assembly). This will help to ensure that the impact hammer
remains level throughout the lift. Using the pile line (aux. hoist), hoist and remove
the impact hammer. After removal, disconnect the 96-inch lifting sling but leave
the 89-inch lifting sling attached to the impact hammer.
u.
If needed, remove the appropriate size guide plate (10, 12, or 16-inch) from the
bottom of the shipping/storage container.
v.
The final arrangement of pile driving system components, ready for assembly
should appear as shown in Figure H-12.
Pile Driver System Component Inventory (Refer To Table H-5 and Figure H-13.)
A quick inventory of the equipment needed for a typical pile driving operation should be
performed before getting underway. Inspect each component to be sure it is serviceable.
Procure any missing or damaged mission-critical components before proceeding.
NOTE
assemble, perform PMCS, and operate the Pile Driver System
and not a comprehensive list of all components delivered with the
system to be used when performing an inventory. Refer to
Components of End Item Section at the end of this Appendix for a
complete list.
H-34 Change 1
