TM 5-3810-307-24-1-1
25. Engine Cooling System.
Lube Type -
AFC
Lube Interval -
Check level daily. Drain and refill every 6000 hours.
Lube Amount -
10.5 gallons (39.7 L)
Application -
Fill radiator to top of filler neck and coolant recovery bottle to marking on bottle.
14. Not Used
25. Outrigger Beams.
Lube Type -
GAA
Lube Interval -
250 hours
Lube Amount -
Thoroughly coat bottom of outrigger beams
Application -
By brush
25. Jack Cylinder Support Tubes.
Lube Type -
GAA
Lube Interval -
250 hours
Lube Amount -
Thoroughly coat inside of jack cylinder support tubes before installing jack cylinders
Application -
By brush
25. Turntable Swing Box.
Lube Type -
GO-85/140
CAUTION
When checking the swing gear box oil level, place the dipstick into the sleeve until the cap is
flush with the end of the sleeve. Do not screw the cap onto the sleeve to check the level.
Lube Interval -
Check every 200 hours. Drain and refill every 1000 hours
Lube Amount -
Capacity 2 quarts (1.89 L)
Application -
Fill to full mark on dipstick
25. Turntable Gear and Drive Pinion.
Lube Type -
GAA
Lube Interval -
Check daily and apply as necessary
NOTE
Apply after each pressure wash.
Lube Amount -
Coat all teeth
Application -
By brush
25. Turntable Bearing.
Lube Type -
GAA
Lube Interval -
250 hours
Lube Amount -
Until grease extrudes the whole circumference of the bearing
Application -
2 grease fittings at the front of the turntable
Rotate the turntable 90 degrees and apply grease to the fittings. Continue rotating 90 degrees and grease
the fittings until the whole bearing is greased.
1-4-7
