TM 5-3810-307-24-1-1
NOTE
Both fan motors are assembled the same. Steps (5) thru (8) apply to either
motor.
(5)
Install brackets (83) and clamp halves (93) on motor (94) with capscrews (92), star washers (91),
and nuts (90).
(6)
Install bracket (84) on fan motor (94) with star washers (89) and nuts (88).
CAUTION
Fan blades bend easily. Handle fan with care to prevent bending fan blades.
(7)
Install fan (87) on shaft of fan motor (94) with retainer (86) and new cotter pin (85).
(8)
Install brackets (83 and 84) with motor (94) on mount bracket (80) with lockwashers (82) and
capscrews (81). Ensure ground wire for fan motor (94) is installed under head of one capscrew
(81).
(9)
Install mount bracket (80) with fan motors (94) in case (103) with lockwashers (79) and capscrews
(78).
(10) Install relay socket (77) on mount bracket (80) with screw (76) and plug in relay (75).
(11) Connect electrical connectors for fan motors (94). Remove tags.
(12) Install coil (74) in case (103) with lockwashers (71 and 73) and capscrews (70 and 72).
(13) Install refrigerant hose (69) between coil (74) and drier (99).
c.
Disassemble compressor (21, Figure 2-1-8) as necessary to replace worn, damaged, or defective
components:
(1)
Hold drive plate (105) from turning and remove capscrew (104) from compressor (21).
(2)
Using suitable puller, remove drive plate (105) and shim(s) (106) from compressor (21).
(3)
Remove snap ring (107) and cover (108) from shaft of compressor (21).
CAUTION
To prevent damage to pulley, ensure claws of bearing puller are hooked into
the top groove of the pulley, not under the grooves.
(4)
Using standard gear puller, remove pulley (109) from compressor (21).
(5)
Remove grommet and electrical lead for coil (111) from holder on compressor (21), then remove
screws (110), and coil (111) from compressor.
d.
Assemble compressor (21, Figure 2-1-8) as necessary:
(1)
Install coil (111) on compressor (21) with screws (110).
(2)
Install grommet and electrical lead for coil (111) in holder on compressor (21).
2-1-56
