TM 5-3810-307-24-1-1
HEATER CONTROL (CARRIER CAB)
Removal
a.
Ensure battery disconnect switch is in OFF position.
b.
Loosen clamp and disconnect heater control cable (1, Figure 2-1-12) from lever on heater shutoff valve at
left side of heater.
c.
Unscrew knob (2) from heater control cable (1).
d.
Remove nuts (3 and 4), and push heater control cable (1) out of dash panel.
e.
Remove washer (5) from heater control cable (1), so it does not fall off and get lost.
f.
Remove all cable ties/clamps securing heater control cable (1) to carrier, and remove cable from carrier.
Installation
a.
Position heater control cable (1, Figure 2-1-12) in carrier, and secure with all cable ties/clamps removed
during removal procedures.
b.
Place washer (5) on heater control cable (1) and insert cable through hole in dash panel.
c.
Secure heater control cable (1) to dash panel with nuts (4 and 6).
d.
Install knob (2) on heater control cable (1) and tighten nut (3) to knob.
NOTE
Ensure control cable knob is pushed all the way in and lever on shutoff valve is
positioned as far as possible toward rear of vehicle before tightening clamp.
e.
Connect heater control cable (1) to lever on heater shutoff valve, pull slack from cable, and tighten clamp.
2-1-71
