TM 5-3810-307-24-1-1
(5)
Install new turn signal/hazard switch (29) on steering column with lockwashers (28) and screws (27).
(6)
Connect electrical leads to turn signal/hazard switch (29), remove tags, and install upper cover (25)
and lower cover (26) on steering column. Ensure covers are secure by snapping slots in covers
onto studs on steering column.
Installation
a.
Position steering valve (11, Figure 2-1-10) below cab weldment (16), insert tilt steering column (15)
through cab weldment (16), and into splines of steering valve (11).
b.
Secure tilt steering column (15) and steering valve (11) to cab weldment (16) with capscrews (12),
lockwashers (13), and washers (14).
c.
Remove caps and connect hydraulic lines (10) to steering valve (11).
d.
Position clamp (9), filler plate (8), and bracket (7) to cab weldment (16) and dash panel ensuring clamp
ends extend through bracket (7).
e.
Secure bracket (7), filler plate (8) and clamp (9) with washers (3 and 6), lockwashers (2 and 5), nuts (4)
and capscrews (1).
f.
Connect electrical connector for tilt steering column (15).
2-1-68
