TM 5-3810-307-24-1-1
Swing Brake.
Controllers (Joysticks).
1.
Remove the plug from the pressure test port
1.
Remove the plug from the pressure test port
on the Hydraulic Test Panel and install the pressure
on the Hydraulic Test Panel and install the pressure
gauge.
gauge.
2.
Set the throttle to 2,800 rpm.
2.
Set the throttle to 2,800 rpm.
3.
Engage the swing brake and mechanical
3.
Lift the armrests in the cab to disable the
swing lock.
controllers.
4.
If the reading is not 10 psi (68.9 kPa) of that
4.
If the reading is not 10 psi (68.9 kPa) of that
listed in the Circuit Relief Settings Table, adjust the
listed in the Circuit Relief Settings Table, adjust the
pressure setting as necessary.
pressure as necessary.
