TM 5-3810-307-24-1-1
and secure the rods to the brackets with nuts,
Installation.
washers, and lockwashers.
1.
If necessary, replace
the
plywood before
4.
Connect all leads to the batteries' terminals start-
installing the batteries.
ing with the positive terminals.
2.
Install each battery.
5.
Close the battery cover.
3.
Install the angle hold down brackets and rods;
NATO SLAVE RECEPTACLE
Removal
a.
Ensure battery disconnect switch is in the OFF position.
b.
Remove capscrew (1, Figure 2-14-5), lockwasher (2), and negative battery cable (3) from NATO slave
receptacle (11).
c.
Remove capscrew (4), lockwasher (5), and positive battery cable (6) from NATO slave receptacle (11).
d.
Remove nuts (7), lockwashers (8), washers (9), screws (10), and NATO slave receptacle (11) from vehicle.
Installation
CAUTION
Observe polarity symbols on rear of receptacle when installing. Ensure "-"
symbol is to rear of carrier.
a.
Install NATO slave receptacle (11, Figure 2-14-5) on vehicle with screws (10), washers (9), lockwashers (8),
and nuts (7).
b.
Connect positive battery cable (6) to "+" side of NATO slave receptacle (11) with lockwasher (5) and capscrew
(4).
c.
Connect negative battery cable (3) to "-" side of NATO slave receptacle (11) with lockwasher (2) and capscrew
(1).
2-14-17
