TM 5-3810-307-24-1-1
3.
Perform the following check to determine switch
Installation.
serviceability.
1.
Connect the electrical leads as marked prior to
a.
Using an ohmmeter, check for continuity
removal.
between the switch terminals with switch in ON or
activated position.
2.
Position the switch on the panel and secure it
with the attaching hardware.
b.
Position switch to OFF. Ohmmeter should
register zero (no continuity).
3.
Reinstall the right side console or install cab front
access panel.
Operate the switch as described in the Operator's
Manual. Observe it for proper functioning in the
applicable circuit.
Continue troubleshooting as
necessary any system or circuit malfunction not
corrected by repair or replacement of the switch or
associated wiring.
Figure 2-14-7. Electrical Switch Removal and
Installation
2-14-20
