TM 5-3810-307-24-1-2
NOTE
Gear driven compressor only.
Install the washer and drive gear retaining capscrew.
Torque Value: 100 Nm [75 ft-lb]
Measure the clearance between the support and the
crankshaft mating surfaces.
Refer to the Crankshaft End Clearance table in Section V.
Position the piston at 90 degrees after top dead center.
This will allow the crankshaft to be installed through the
connecting rod.
Install a new gasket on the support.
Install the crankshaft.
Install the two captive washer capscrews.
CAUTION
Do not use the capscrews to pull the support
housing/crankshaft
assembly
into
the
crankcase. Damage to the connecting rod
can result.
Change-1 12-49