TM 5-3810-307-24-2-2
Install the expanding plug in the barring tool hole.
Coat both sides of the inspection plate gasket with
K&W Copper Coat.
13 mm
Install the inspection plate.
Tighten to 24 Nm [18 ft-Ibs].
Wet Clutch Application
Perform all the steps in the procedure for dry clutch
installation in addition to the following:
Coat the flywheel housing drain plug with pipe sealant
and install in the hole in the bottom of the flywheel
housing.
Tighten the plug.
Refer to the pipe plug torque value in Section V
Engine Components Specifications Group 18.