TM 10-3950-672-24-2
Caution: Do not lubricate the side that is against the
cylinder block.
Apply a coat of Lubriplate 105 to the new upper
bearings.
Use the pin to push the bearing shell into position. Use
the pin to push against the end of the bearing with the
tang. Push the bearing in slowly being sure it is aligned
with the block. Make sure the tang on the bearing sets
into the notch.
Note: Make sure the tang on the bearing sets into the
notch in the bearing saddle.
Install the lower bearings into the caps. Apply a coat of
23mm
Caution: Make sure the caps are correctly installed
with the number towards the oil cooler side of the
engine.
Install a main bearing cap after each upper bearing is
installed to keep the bearing in place while the other
uppers are installed.
Tighten the capscrews to 50 N [37 ft-lbs].
m
Do not tighten to the final torque value at this time.
5-229