TM 10-1670-298-20&P
Figure 2-20. Fabrication and Installation Details of the Safety Clip Retaining Straps
f. Position the folded end on top of the quick release strap with the folded end edge located 1 7/1 6-inches (4.920
cm) from the end of the quick release strap webbing where the lug is attached.
NOTE
A replacement, fabricated safety clip retaining strap may be secured to any serviceable
quick release strap.
g. Stitch the folded end of the safety dip retaining strap to the quick release strap with a box stitch formation using
the specifics In Table 2-3.
h. Insert safety dip into the 3/8-inch (O 956 cm) loop of the safety clip retaining strap.
REPLACE
A defective quick release strap shall be replaced with a serviceable item from stock.
2-42
