TM 10-1670-298-20&P2.17 SLINGASSEMBLYThis task covers a Inspect b Repair c. ReplaceINITIALSETUPToolsReferencesIndustrial Sewing Machine (See Table 2-2)Paragraph 2.7Paragraph 2 8Materials/PartsParagraph 2 9Beeswax, Technical (Item 1, Appendix E)Cloth, cotton duck, OD, 12 29 oz (Bulk, Appendix C)Cotton webbing, Type II (Bulk, Appendix C)Nylon webbing, OD Type VII (Bulk, Appendix C)INSPECTConduct a technical/rigger-type inspection in accordance with the instructions contained in paragraph 2.9REPAIR1. SCUFFPAD The octagonal shaped scuff pad (Figure 2-15) has two reinforced holes which permit two V-rings topass to the underside of the pada Restitching. Restitch according to original construction using specific data In Table 2-3.b Darning. Darn holes and tears In the scuff pad as outlined In paragraph 2 8 and as specified in Table 2-3.c Patching. Patch a hole or tear with the same type of matenal used in original construction, using Figure 2-16,the specifics in Table 2-3, and as outlined in paragraph 2 8.d Restencil. Restencil In accordance with paragraph 2 8e ReplacingV-RingHoleReinforcements. Cut the stitching that secures the defective reinforcement to the V-ring hole and remove the reinforcement Cut a 12-inch (30 480 cm) length of Type II cotton webbing and waxthe webbed ends Position the cut length of webbing around the V-ring hole and install according to FigureTable 2-3, and paragraph 2 82-36
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
