TM 10-1670-298-20&P2.18 QUICKRELEASESTRAPS.This task covers:a. Inspectb. Repairc. ReplaceINITIALSETUPToolsReferencesIndustrial Sewing Machine (See Table 2-2)Paragraph 2 9Materials/PartsQuick release strap (Appendix C)Type IV Nylon webbing (Bulk, Appendix C)INSPECTConduct a technical/rigger-type inspection in accordance with the instructions contained In paragraph 2 9.REPAIR1. RESTITCHING. Restitch the quick release strap and safety clip retaining strap according to original constructionand Table 2-3.2. FABRICATIONOFTHESAFETYCLIPRETAININGSTRAP.NOTEBefore discarding a defective safety dip retaining strap, insure the safety clip has beenremoved and retained for reuse.An unserviceable safety dip retaining strap shall be removed from the fixed quick release strap and replaced witha fabricated item as follows:a. Remove the defective retaining strap by cutting the retainer strap flush with the adjoining quick release strap.b. Cut a 13-inch (32.020 cm) length of 1 -inch (2.54 cm) wide Type IV nylon webbing and sear endsc Mark the length of webbing 2 3/4-inches (6 985 cm) from one end.d. Fold the marked webbing end back to the mark and stitch a 1 -inch (2.54 cm), 3-point, WW stitch formation (Figure 2-20) using specifics In Table 2-3. Insure that a 3t8-inch (9.525 cm) loop remains on the sewn end of the web after stitching is complete.e. Fold the opposite end of the retaining strap under and back 1/2-inch (1.270 cm) (Figure 2-20).2-41
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
