c. Cleaning, Inspection and Repair.
d. Reassembly. Refer to figure 3-3 and
(1) Clean all parts. reassemble boom.
e. Installation.
(2) Inspect for cracks or other obvious
damage.
1) Install male boom section.
(3) Weld cracks and broken welds as
(2) Install boom extension cylinder (para 3-2).
necessary.
(3) Install boom topping cylinder (para 3-1).
(4) Replace defective parts as required.
(4) Install boom (para 2-6).
(.
Section II. MAST ASSEMBLY
3) Disconnect hydraulic lines.
3-4. Winch Assembly
b Disassembly. Refer to figure 3-4 to
a. Removal
disassemble winch assembly to extent required to
1) Remove load block (TM 10-3950-203-20).
effect repairs
(2) Drain winch case
3-7
