c. Cleaning and Inspection.
e. Installation.
(1) Clean all parts.
(1) Connect slewing cylinder to linkage arm.
(2) Inspect for obvious damage.
(2) Install mast frame (fig. 2-2).
(3) Replace defective parts as necessary.
(3) Inspect and adjust turntable rollers (TM
d. Reassembly. Refer to figure 3-6 to reassemble
10-3950-203-20).
turntable and slewing linkage components.
Section III. ELECTRICAL SYSTEM
3-7. Generator
a. Removal. Remove generator (TM 10-3950-
20-20).
b. Disassembly. Refer to figure 3-7 and
disassemble generator to extent necessary to effect
repair
Figure 3-7. Generator, exploded view.
3-12
