b. Cleaning, Inspection and Repair.
are worn or warped more than 0.010 inch, the block must
(1) Soak engine block in strong caustic solvent for
be replaced.
at least two hours, then remove and clean with steam.
c. Reassembly.
(2) Inspect for cracks, excessive wear, or other
(1) Reassemble and install parts on engine block as
defects.
shown in figure 5-12.
(3) Use a straight edge and feeler gage to check the
(2) Install flywheel housing (para 5-2).
machined surfaces of the block. If the surface
(3) Install camshaft (para 5-10).
(4) Install crankshaft (para 5-9).
5-15
