TM 10-3950-672-10
Table 6-1. Operator Troubleshooting (continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 6.
Swing system failure.
a.
Contact Organizational Maintenance.
42.
SWING BRAKE SYSTEM WILL NOT OPERATE.
Step 1.
Low hydraulic oil.
a.
Check hydraulic oil level. Refer to PMCS in Section 5. If
OK, do step 2.
b.
Service hydraulic reservoir.
Step 2.
Swing system failure.
a.
Contact Organizational Maintenance.
6-3.
INSTALLING CABLE ON THF HOIST.
WARNING
Wear heavy gloves and safety glasses when working
with the hoist cable. Failure to follow this warning could
result in personal injury.
CAUTION
If cable is wound from the storage reel onto the drum,
the reel should be rotated in the same direction as the
hoist.
NOTE
The cable should preferably be straightened before
installation on the hoist drum.
Install cable on the hoist drum using Figure 6-3 and the following procedures.
a.
Position the cable over the boom nose sheave and route to the hoist drum.
6-29
