Figure 4-42. Heater control panel, removal, disassembly, reassembly and installation (sheet 1 of 2).
(2) Visually inspect valve spring for
4-50. Pressure Primer Discharger (Ether Injector)
deformation, for tension, seating of valve at discharge
nozzle, or other defect. Be sure cotter pin hole in valve
and remove pressure primer discharger in numerical
stem is not elongated so that discharge trigger has
sequence. Install in reverse order.
excess movement before moving valve from discharge
nozzle. Be sure that piercing pin is sharp enough and
long enough to open cartridge during travel of holder
numerical sequence. Reassemble in reverse order.
down body threads.
c. Cleaning, Inspection, and Repair.
(3) Repair by replacing worn or defective
(1) Clean all parts in an approved cleaning
parts.
solvent and dry thoroughly.
4-42
