(2) Remove starter motor and solenoid (TM 5-
(13) Install flywheel housing by reversing the
3810-201-12).
procedure in steps (1) through (12) above.
(3) Remove flywheel (para 3-38).
(4) Remove oil pan (para 3-43).
b. Cleaning, Inspection, and Repair.
(5) Remove
capscrews
lockwashers (32), and flatwashers (33) securing housing
(1) Clean all parts and dry thoroughly before
(7) to engine.
inspection or installation.
(6) Remove nuts (3, fig. 3-18), lockwashers
(2) Inspect the housing and rear plate for
(2), and capscrews (30, fig. 3-45) securing flywheel
cracks, breaks, elongated holes, or damaged threaded
housing (7) to rear plate (16).
surfaces. Inspect mounting hardware for burs or other
(7) Remove housing (7) from rear plate (16)
damage.
and discard gasket (11).
(3) Repair or replace defective housing or rear
(8) Remove four capscrews (1), lockwashers
plate. Replace all gaskets, and defective seals.
(2), flatwashers (3), then remove injection pump drive
cover (28) and gasket (27) from housing (7).
3-41. Flywheel Housing (Engine Model D333TA)
(9) Remove eyebolt (6), stud (18), and stud
(25) if required.
a. Removal and Installation.
(10) Loosen adjustment screw (8), then
remove four capscrews (1), lockwasher (2), flat washers
(1) Remove the engine (para 2-9).
(3), blower drive cover (4) and gasket (6) from housing
(2) Remove starter motor and solenoid (TM 5-
(7). Discard the gasket (5).
3810-201-12).
(11) Remove seal (24) from housing (7).
(3) Remove flywheel (para 3-39).
(12) Remove capscrews (21), lockwasher (20),
(4) Remove oil pan (para 3-44) and
nuts (19), rear plate (16), and gasket (17) from engine.
disconnect oil return line from housing.
1
Pointer
9
Plug
2
Capscrew (2 rqr)
10
Lockwasher (13 rqr)
3
Lockwasher (6 rqr)
11
Bolt (4 rqr)
4
Cover
12
Bolt (9 rqr)
6
Housing
13
Ring gear
6
Gasket
14
Flywheel
7
Plate
15
Lock
8
Capscrew (4 rqr)
16
Screw (9 rqr)
Figure 3-46. Flywheel and Flywheel Housing, exploded view.
AGO 20051A
3-57
