(4) Slide plug (10) into sleeve (12) against
NOTE
tension of spring (11), then lift rocker arm (16), shaft and
supports (5) off cylinder head (4) as an assembly.
The sleeve bearing (4) is pressed into
Remove plug (10) and spring (11).
rocker arm (6) and should not be
(5) Repeat steps (2) through (4) as required
removed unless replacement is
to remove remaining rocker arm,.
required.
(6) Lift pushrods (9) out of block.
(7) Remove support (9, fig. 3-48) from each
(9) Press bearing (4) out of rocker arms as
end of shaft (7). Slide rocker arm (6) off of shaft (7).
required.
(8) Remove nut (5) and adjusting screw (11)
(10) Remove cam spring socket (12) from
from rocker arm (6).
pushrod (18).
(11) Remove pushrod socket (14) and lever
socket (15).
(12) Remove screw (27) and pin (18) from
1
Plug (6 rqr)
15
Exhaust lever rocket (6 rqr)
2
Spring (6 rqr)
16
Cam lever (6 rqr)
3
Sleeve (6 rqr)
17
Pin (6 rqr
4
Sleeve bearing (6 rqr)
18
Pin (8 rqr
5
Locknut (6 rqr)
19
Cover
6
Rocker arm (6 rqr)
20
Stud (24 rqr)
7
Shaft (6 rqr)
21
Gasket (6 rqr)
8
Plug (6 rqr)
22
Lever support (6 rqr)
9
Support (12 rqr)
23
Locker support (24 rqr)
10
Self-locking screw (12 rqr)
24
Nut (24 rqr)
11
Adjustment screw (6 rqr)
25
Pin (6 rqr)
12
Cam spring rocket (6 rqr)
26
Cam roller (6 rqr)
13
Pushrod (6rqr)
27
Screw, special ( rqr)
14
Pushrod socket (6 rqr)
Figure 3-43. Rocker arm, pushrod, and cam lever, exploded view.
AGO 20051A
3-53
