1
Steering wheel
15
Vertical propel gear
2
Gear, bevel
16
Jaw clutch
3
Locknut
17
Bolt (2 rqr)
4
Flatwasher
18
Shifter collar half (2 rqr)
5
Adjusting collar
19
Lockwasher (2 rqr)
6
Hand lever
20
Nut (2 rqr)
7
Cam
21
Shaft
8
Shaft
22
Lockwasher (4 rqr)
9
Gear, bevel
23
Capscrew (4 rqr)
10
Lubricating line
24
Revolving frame
11
Lockwasher (2 rqr)
26
Bracket
12
Nut (2 rqr)
26
Cotterpin (6 rqr)
13
Bolt (2 rqr)
27
Pin (3 rqr)
14
Shifter fork half (2 rqr)
Figure 4-2. Steering wheel shaft, and vertical propel gear, installed view.
(9) Press four sleeve bearings (5) out of bracket
(6) Remove two cotterpins (3) from pin (20);
(6).
remove pin (20) from shaft (23); remove spur gear (21)
NOTE
from shaft (23), then remove key (22) from shaft (28).
(7) Lift shaft (23) from bracket (6); remove nut
Do not remove sleeve bearings
(9), adjusting collar (8), bevel gear (7), screw (24), and
unless they are to be replaced.
key (25) from shaft (23).
(8) Remove four capscrews (17) and
(10) Install steering wheel and shafts by
lockwashers (18) from bracket (6), then lift bracket (6) off
reversing the procedure in steps (9) through (1) above.
of washer (19).
AGO 20051A
4-4
